Comments
-
nice video thanks
-
Do the transmission lines have to be put back on from where they were taken from, or can either line go to either nipple?
-
Thank you for this video presentation. I've just been quoted AU$1008.00 for this solenoid pack from our local Stealer. Ouch ..
-
i have a 1998 dodge 3.8 grand caravan sport i put it in drive and it instantley stops it runs good in reverse
-
i dont understand the reason for a new solenoid pack, if it was only leaking fluid, why not just change the gasket? but great how-to video thanks
-
I followed this video to fix a P750 code,LOW REVERSE SHIFT SOLENOID MALFUNCTION! So i jumped on it took out the air in-take,removed the 2 trnny hoses,unscrewed the input speed sensor. Drop my pan under before transmission fluid pours out below. Removed the 3 10mm bolts to release the solenoid pack,and tested #4 male #7 male on the solenoid pack with my multimeter. Its bad gotta replace it, No problem can't wait to get one and put it on. Thank you boss!
-
I need this done too- how much should I pay fro this procedure ?
-
is relearn neccesary? i dont have a scanner. can i rent one? what is the scanner called?
-
Hey! Unhook the battery before you work on your car and use eye protection.
-
gracias from merced ca
-
Thanks
-
i dont have a scanner or the owners manual, how do i do the relearn,and do i need the relearn.
-
LOOKS GOOD! thank you! i have a 2000 that needs this!
-
greg shaver
-
Thanx great vid. Replaced wifes trany. Install went great. road test not so good. stuttered 1st-2nd 2nd -3rd. Had quick-learn done to no avail. On way home stuttered/ slipped in out 3rd@ 55mph. stopped for a left turn stuck in 1st. error codes P0732/P1776. long slow ride home. Moveras sent me a new solenoid pack. Back to go get greasy thanxs for heads up.
-
I couldn't remove the sensor so I used a small regular wrench size 10 to reach to the screw underneath the sensor.. So I did the job without removing the sensor
-
I followed this procedure .. Its now running very well.. The problem is solved.. Thank you very much.. Just one question .. Cuz I installed the gasket without applying any glue or gasket maker is that OK? Or I should expect the gasket to fail soon ?
-
Before removing the solenoid pack, I try to blow off the backside of the area with shop air to remove all the road debris that collects in this area. You don't want anything to fall into the holes once the pac is removed. I spend some time cleaning up the mounting surface with a rag coated with brake cleaner to ensure nothing is going to cause a problem due to dirt falling down inside the hole areas.
-
I just changed this, and everything when fine, by now my Van just dies for no reason while driving. It's starts back up after 5 minutes or so. Has anyone else exsperence this? Also, I didn't do a relearn proceedure, is that what's wrong?
-
Well done! Your step by step is most appreciated!
3m 54sLength
A common problem on Caravan's is the transmission solonoid pac's leak. They cannot be repaired, they must be replaced. Here's how we do it.